Apply Tape In Hair
1. Section Your Hair
Use a tail comb to create a horizontal parting just above your ears, taking a 1–2 cm section of natural hair. Thinner sections (no thicker than 1 cm) prevent bulk.
Start with clean, dry hair free of oils or conditioner.
2. Apply the First Tape Weft
Place the weft under your natural hair, ¼ inch from the scalp (use a ruler to check!). This gap prevents discomfort and slippage.
Peel the protective backing off one tape tab.Then apply tape in hair.
3. Secure the Bond
Press firmly for 10–15 seconds—adhesive needs heat and pressure to activate
Comb through the sandwiched hair to ensure no tangles.
4. Attach the Top Weft
Squeeze the “sandwich” together, again holding for 10+ seconds.
Remove the second tab’s backing and align it directly over the bottom weft.
5. Repeat Strategically
Leave 1 cm between rows to apply tape in hair for avoiding bulk.
Work upward in staggered rows (like brickwork) for even distribution.
6. Final Seal
Gently run a flat iron (300°F max) over each bond for 2–3 seconds to melt the adhesive slightly.
Must-Know Warnings
🔹 Apply Tape In Hair-Do’s & Don’ts
- DO Prep Hair Properly
- Wash with sulfate-free clarifying shampoo (no conditioner/oils!).
- Why? Oils weaken adhesive bond.
- DON’T Place Too Close to Scalp
- Leave ¼ inch gap to prevent:
- Pulling discomfort
- Premature slippage
- Scalp irritation
- Leave ¼ inch gap to prevent:
- DO Use the “Sandwich” Method
- Natural hair must be thinner than the tape tab (1cm max).
- Pro tip: Hold wefts vertically to avoid folding.
- DON’T Skip the Press-and-Hold Step
- Adhesive needs 10+ seconds of firm pressure per tab to bond fully.
- DO Stagger Rows Like Brickwork
- Alternate placement 1cm apart for seamless volume.
⚠️ 3 Hidden Risks to Avoid
❌ Sleeping on Wet Hair
- Weakens tapes → slippage!
❌ Overlapping Tapes
- Causes bulky, visible lumps.
❌ Using Oily Products Near Roots
- Stick to alcohol-free dry shampoo.
Apply tape in hair-Hidden Risks
⚠️ Oily Products Near Roots
- Dry shampoo is okay (alcohol-free), but avoid serums or sprays near tapes.
⚠️ Skipping Maintenance
- Remove and re-tape every 4–6 weeks to prevent matting.
💡 Apply tape in hair-Pro Application Hacks
✔ Pre-Section Hair
- Clip away unneeded hair with alligator clips.
✔ “Comb Through” Before Pressing
- Ensures no tangles under tapes.
✔ Flat Iron on Low Heat
- Gently press bonded area (300°F) for extra hold.
📸 Visual Tip: Show a ruler next to the ¼ inch gap in demo photos!
Final Note: Remove every 2-4 weeks to prevent matting.
💬 Love these tips? Share your tape-in experiences or questions below—we’d love to hear from you!